Filter
Top Products
Prestige 660H/HW Series User’s Guide
83 Chapter 7 Wireless LAN (Prestige 660HW)
• Use the Local User Database if you have less than 32 wireless clients in your network.
The Prestige uses MD5 encryption when a client authenticates with the Local User
Database
7.2.3 Restricted Access
The MAC Filter screen allows you to configure the AP to give exclusive access to devices
(Allow Association) or exclude them from accessing the AP (Deny Association).
7.2.4 Hide Prestige Identity
If you hide the ESSID, then the Prestige cannot be seen when a wireless client scans for local
APs. The trade-off for the extra security of “hiding” the Prestige may be inconvenience for
some valid WLAN clients. If you don’t hide the ESSID, at least you should change the default
one.
7.2.5 G-plus
G-plus is an enhancement to the IEEE 802.11g wireless standard. G-plus combines multiple
frames into a larger frame size. This increases wireless transmission speeds by allowing larger
frames (up to 4 KB) to be sent.
G-plus speed applies only to unicast traffic (not broadcast or multicast). G-plus is
automatically disabled if wireless transmission speeds fall below 11 Mbps.
7.2.6 Configuring Wireless LAN on the Prestige
1 Configure the ESSID
and WEP in the
Wireless screen. If you
configure WEP, you
can’t configure WPA or
WPA-PSK.
2 Use the MAC Filter
screen to restrict access
to your wireless
network by MAC
address.
3 Configure WPA or
WPA-PSK in the
802.1x/WPA screen.
You can also configure 802.1x wireless client authentication in the 802.1x/WPA screen.
4 Configure the RADIUS authentication database settings in the RADIUS screen.
5 Configure the built-in authentication database in the Local User Database screen.