Filter
Top Products
Prestige 794M User’s Guide
105 Chapter 9 Static Route
Table 56 Advanced: Static Route
LABEL DESCRIPTION
Destination This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use a
subnet mask of 255.255.255.255 in the subnet mask field to force the network number
to be identical to the host ID.
Netmask Enter the IP subnet mask in dotted decimal notation.
via gateway Enter the IP address of the gateway.
The gateway is a router or switch on the same network segment as the device's LAN or
WAN port. The gateway helps forward packets to their destinations.
or Interface Select the interface through which packets are to be forwarded.
Cost IP routing uses hop count as the measurement of cost, with a minimum of 1 for directly
connected networks. Enter a number that approximates the cost for this link. The
number need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is
usually a good number.
Apply Click Apply to save the settings.
Cancel Click Cancel to start configuring the screen again.