Filter
Top Products
VES-1000 Series Ethernet Switch
System Maintenance 2 11-5
Table 11-D Menu 24.11.1.1 - Secured Client Configuration
FIELD DESCRIPTION EXAMPLE
Secured IP
addr_start To allow a range of computers to use Telnet, FTP or ICMP services then enter
the first IP address in the range here.
The default value for a start and end address is 0.0.0.0, which means you don’t
care which host is trying to use a service (Telnet, FTP, or ICMP).
If you enter an IP address in this field, the VES-1000 Series switch will check if
the client IP address matches the value here when a (Telnet, FTP, or ICMP)
session is up. If it does not match, the VES-1000 Series switch will disconnect
the session immediately. If the service field is disabled in menu 24.11, then this
field and the next field are N/A.
0.0.0.0
addr_end To allow a range of computers to use Telnet, FTP or ICMP services, enter the
end IP address in the range here. To allow a single computer to use Telnet, FTP
or ICMP services, enter the same IP address here as in the previous field.
0.0.0.0
Service Type
TELNET
Service
Press [SPACE BAR] to select Yes or No and then press [ENTER] to
activate/deactivate this service for the trusted computers specified above.
Yes
FTP Service Press [SPACE BAR] to select Yes or No and then press [ENTER] to
activate/deactivate this service for the trusted computers specified above.
Yes
ICMP Service Press [SPACE BAR] once to select Yes or No and then press [ENTER] to
activate/deactivate this service for the trusted computers specified above.
Yes
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to Cancel" to
save your configuration, or press [ESC] to cancel.
11.4 Hardware Monitor
Enter 12 from Menu 24 – System Maintenance to go to the next menu shown.