CHAPTER
28-1
User Guide for Cisco Digital Media Manager 5.4.x
OL-15762-05
28
Emulate the DMP Remote Control
for Use with Cisco Cast
Revised: September 17, 2012
OL-15762-05
•
Concepts, page 28-1
•
Procedures, page 28-4
Note We do not support remote control emulation on a DMP 4310G.
Concepts
•
Overview, page 28-1
•
Restrictions, page 28-2
•
Workflow to Provision Emulator Service for IP Phones, page 28-3
Overview
Topics in this section describe a software-based emulator that you can use in place of, or in addition to,
the remote control unit for a DMP.
Note • Although Cisco sells a physical remote control device for use with DMPs that deliver Cisco Cast programming to
their attached displays, the remote control unit is an optional accessory for a DMP.
• To learn about the remote control unit, see its documentation on Cisco.com.
• The emulated remote control supports changing channels for Cisco Cast, navigating in the Cisco Cast menu system, and
adjusting audio volume settings for a DMP.
Audience
We prepared this material with specific expectations of you.
You want to emulate the DMP remote control on mobile phones or Cisco IP phones.
