No. 99MBA038A
1-4
1.1.4 Measurement Screen
<Measurement standby screen (example of circle measurement)>
Circle
Measurement result window
Counter
Navigation
window
Fig. 1-1-4
F1: Recalls the measured features and performs calculations, etc.
F2: Recalls the measured features to adopt the representative point coordinates of those
features as measured points for the current measurement.
F3: Changes the measurement conditions ("Output Items", "Auto.MeasuringCompletion").
F4: (Enables/disables input of measured points based on edge detection if OPTOEYE is
mounted.)
F5: Completes the input operation of measurement points and outputs results at the multi-point
measurement.
In the navigation window, the next location to be measured flashes to navigate the next
measuring position. The flashing location moves as shown below, each time a point is entered.
1/3 2/3 3/3
1
2
3
1
2
3
1
23
Fig. 1-1-5
TIP
• When the results are displayed at the end of the measurement, the navigation window
returns to its initial input standby state (“1/3” in the above figure), and the same
measurement is repeated automatically.
• To perform a different measurement, press a different measurement command key.
