No. 99MBA038A
2-4
No. Operation Screen display and remarks
4
Measuring edge (B)
Measure edge (B) at two points.
3
4
(B)
<Remarks>
Follow the information displayed on the
screen to perform the measurement.
5
Results display
The measurement results (A1, A2) for the angle formed by
edge (A) and edge (B) are displayed on the screen.
A1
A2
N0001
X =
*.***
Y =
*.***
A1= 150.0142
A2= 209.5818
NOTE
• Note that the obtained angle (A1) varies depending on the order in which the edges are
measured, as shown below.
Measurement
method 3
Measurement
method 2
Measurement
method 1
Measurement
method 4
1
2
3
4
1
2
3
4
1
2
3
4
1 2
3
4
• The X and Y coordinate results of the intersection point vary depending on the position
and orientation of the model workpiece on the XY table. In order to obtain measurement
results that match the dimensions shown in the section titled “Model Workpiece”, before
starting the measurement, perform the operation described in Section 3.2 “Aligning Part
Coordinate System Using Edges as Reference”.
• Angle units can be switched between degrees (decimal notation) and degrees, minutes
and seconds (sexagesimal notation). See Chapter 6 of the “Software Guide” for the
switching procedure.
