Mitutoyo qm-data 200 Manual

A SERVICE OF

next previous

No. 99MBA038A

3-2

3.2 Aligning Part Coordinate System Using Edges as

Reference

[Purpose of Practice]

To align the part coordinate system based on two edges that are perpendicular to each

other, using the model workpiece.

[Description of Operation]

The part coordinate system is set using the coordinate system alignment macro command

(1).

(0, 0)

X

Y

Fig. 3-2-1

[Operating Procedure]

Table 3-2-1

No. Operation Screen display and remarks

1

Preparing the workpiece

Set the model workpiece on the XY table as shown below,

and focus on it.

–

2

Selecting the coordinate system alignment menu

Press

.

The coordinate system alignment function menu is

displayed.

–

3

Selecting the coordinate system alignment macro

command (1)

Press the numeric key corresponding to

.

–