Mitutoyo qm-data 200 Manual

A SERVICE OF

next previous

No. 99MBA038A

4-6

4.3 Recalling Measured Features to Construct a New

Feature

[Purpose of Practice]

This section presents practice on recalling measured features to calculate a new feature.

In this section, the measurement results for two circles (A) and (B) are recalled to calculate

the midpoint between them.

(A)

(B)

Fig. 4-3-1

[Operating Procedures]

Table 4-3-1

No. Operation Screen display and remarks

1

Preparing the workpiece

Set the model workpiece on the XY table as shown

below, and focus on it.

–

2

Aligning the part coordinate system

For the aligning procedure, see Section 3.2 “Aligning

Part Coordinate System Using Edges as Reference”.

The explanation for the operations from

step 3 onward assumes that the part

coordinate system has been aligned.

3

Selecting the circle feature measurement command

Press

.

–