Mitutoyo qm-data 200 Manual

A SERVICE OF

next previous

4. Applied Measurements

No. 99MBA038A

4-9

4.4 Performing Tolerance Judgment

[Purpose of Practice]

To compare measurement results with nominal values and tolerance zones, and to make a

GO/NG judgment.

In this section, circle (A) is measured and the tolerance judgment is performed.

(A)

Fig. 4-4-1

[Operating Procedures]

Table 4-4-1

No. Operation Screen display and remarks

1

Preparing the workpiece

Set the model workpiece on the XY table as shown

below, and focus on it.

–

2

Aligning the part coordinate system

For the aligning procedure, see Section 3.2 “Aligning

Part Coordinate System Using Edges as Reference”.

The explanation for the operations from

step 3 onward assumes that the part

coordinate system has been aligned.

3

Selecting Menu 2

Press

.

–