4. Applied Measurements
No. 99MBA038A
4-5
No. Operation Screen display and remarks
4
Selecting output item
Use the up and down cursor keys
to
highlight the item to be selected.
Each time the [ENTER] key is pressed, an asterisk
(*) appears to the left of the highlighted item, or is
removed from the item.
In this example, place an asterisk (*) next to “Angle:
A1” only.
Coord: Y
RadDist: L
Angle: A
*
Angle: A1
Angle: A2
Coord: X
Coord: Y
RadDist: L
Angle: A
*
Angle: A1
<Remarks>
In some cases, it may not be possible to
display all of the output items at once. In such
cases, scroll through the screen to view the
hidden items using the up and down cursor
keys
.
5
Completing output item selection
Press the [F5] function key corresponding to
.
<Remarks>
Only the output items with an asterisk (*) next
to them will be output after the measurement.
6
Measuring edges (A) and (B)
Measure edges (A) and (B).
3
2
1
(B)
(A)
4
<Remarks>
Follow the information displayed on the screen
to perform the measurement.
The procedure is the same as steps 3 to 4 in
Section 2.2 “Measuring Angle Between Two
Edges”.
7
Result display
Only the measurement result for the intersection
angle (A1) between edge (A) and edge (B) is
displayed on the screen.
A1
N0001
A1 = 150.1826
TIP
The output item selection result made in the above example remains in effect until the
power is turned off.
