No. 99MBA038A
2-2
No. Operation Screen display and remarks
3
Measuring circle (A)
At any three points on the circumference of circle (A),
center the projection screen crosshairs and then press the
[LOAD] key.
2
(A)
1
3
<Remarks>
Follow the information displayed on the
screen to perform the measurement.
4
Results display
The circle (A) measurement results are displayed on the
screen.
D
Diameter
N0001
X =
*.***
Y =
*.***
D = 4.018
NOTE
• The three points that are measured should be spaced as far apart from each other as
possible on the circumference in order to measure the circle precisely.
• The X and Y coordinate results indicating the circle’s center position vary depending on
the position and orientation of the model workpiece on the XY table. In order to obtain
measurement results that match the dimensions shown in the section titled “Model
Workpiece”, before starting the measurement, perform the operation described in
Section 3.2 “Aligning Part Coordinate System Using Edges as Reference”.
TIP
• If an incorrect position was measured, it is possible to cancel the measured point data
by pressing the [CANCEL] key prior to entering the last measurement point. If the
[CANCEL] key is held down, the system returns to the standby state for the first
measurement point.
• The last measurement point cannot be canceled. If the last measurement point is not
correct, redo the measurement.
