Appendix
154
9
Limitation
❒ There may be a difference in the size of the image when it is printed at the des-
tination.
❒ If you set an original larger than DLT /A3 on the exposure glass, only an area
of DLT /A3 is scanned.
Note
❒ Even if an original is correctly placed on the exposure glass or in the Docu-
ment Feeder (ARDF), a margin of 3mm around each edge of the original may
not be sent.
❒ If the receiver uses paper narrower than the original, the image will be re-
duced to fit the paper width.
❒ The machine detects paper sizes in the following ways.
• When you set an original in the Document Feeder (ARDF), an original wid-
er than about 10.4" (263mm) is scanned as 11"×17" size.
An original narrower than about 9.1" (230mm) will be sent as 8
1
/
2
"×11" or
8
1
/
2
"×14" size.
Originals up to 17” (432mm) in length can be scanned.
• Refer to the table below for the sizes the machine can detect when you set
an original on the exposure glass. Because the machine scans in non-stand-
ard size documents as one of the standard sizes, parts of the image may be
truncated depending on the length of the document. For how to set non-
standard size documents, see P.45 “Choosing the Area to be Scanned Yourself
(Irregular Scan Area)”.
-
--
-Maximum Scan Area
Memory Transmission/Immediate Transmission
• From the Document Feeder (ARDF): 11"×17"/297×432mm (W×L)
• From the exposure glass: 11"×17"/297×432mm (W×L)
Length
width
∼
”9.80 ”9.80
∼
”10.79 ”10.79
∼
”12.44
”12.44
∼
∼
”9.57 not detected LT
L
LT
L
LG
L
”10.55
∼
LT
K
DLT
L
DLT
L
DLT
L
