EFP9800 ESC/POS Commands
3255 4073– 002 6– 17
Command Setting(s) Not Used in Page Mode
Select Print Modes (1B 21) Double-Strike, All 7 x 7 fonts
Select Print Modes (1B 22) All 7 x 7 fonts
Select Bit Image Mode (1B 2A) Double Density
Set/Cancel Emphasized Mode (1B 45) All
Set/Cancel Double-Strike Mode (1B 47) All
Set/Cancel 90 Degree Clockwise Rotation (1B 56) All
Select Justification (1B 61) All
Set/Cancel Upside Down Printing (1B 7B) All
Print Downloaded Bit Image (1D 2F 00) Double Density
Set Left Margin (1D 4C) All
Set Printable Area Width (1D 57) All
Select Printing Position of HRI Characters (1D 48) All
Select Pitch of HRI Characters (1D 66) All
Select Height of Bar Code (1D 68) All
Print Bar Code (1D 6B) All
Select Horizontal Size of Bar Code (1D 77) All
Select Print Direction in Page Mode
Selects the printing direction and start position in page mode. See the
illustration. Default for n is 0. For more information see “Page Mode” later in
this section.
• The command is valid only in page mode.
• The command is ignored if the value of n is out of the specified range.
• The command can be sent multiple times so that several different print
areas, aligned in different print directions, can be developed in the printer’s
page buffer before being printed by the Eject Slip command (0C).
