Diagnostics and Print Tests
3–28 3255 4073–002
Diagnostic Print Tests
Three diagnostic print tests and a general print test are available:
• Print configuration, ROM CRC, and internal switch packs information.
• Continuous slip printing.
• Print each character in the ASCII character set.
• General print test
The following procedures describe how to run each of these tests.
Print Configuration Information
This test produces a printout of all ROM CRC, internal switch pack, and
configuration information. See the sample printout later in this section.
1. Turn the printer off.
2. Turn the printer to the back to access the DIP switches and write down the
current switch settings.
3. Set the DIP switches to the following settings:
Switch
1
Switch
2
Switch
3
Switch
4
Switch
5
Switch
6
Switch
7
Switch
8
ON OFF N/A ON ON ON N/A N/A
4. Turn the printer back on to begin printing the test.
5. Turn the printer off to stop the test.
6. Turn the printer off and reset the DIP switches to what they were when you
started.
For normal operation settings, see “Setting Switches” in section 5.
7. Turn the printer back on to begin normal operation.
