EFP9800 ESC/POS Commands
3255 4073– 002 6– 23
Notes:
• When the paper selection changes, if slip or validation was previously selected, the
slip or validation paper is ejected.
• When either slip or validation is selected, the printer waits for the paper to be
inserted.
• When both slip and receipt/journal paper are selected at once, printing on the
pressure roll is possible only when pressure-sensitive paper is used.
• If the previously selected paper is re-selected, no action takes place.
Select Paper(s) For Setting Line Spacing
Selects paper for use with the following commands:
• Select Default Line Spacing (1B 32)
• Set Line Spacing (1B 33)
• Set Slip Eject Length (1B 43)
The command is ignored if n is out of range. The default is n = 15.
Hexadecimal Decimal ASCII
1B 63 31 n 27 99 49 n ESC c 1 n
Paper Type Status
Bit Paper Type 0 1
0 Receipt/Journal Paper Not Selected Selected
1 Receipt/Journal Paper Not Selected Selected
2 Slip Not Selected Selected
3 Validation Not Selected Selected
4-7 Undefined
Note: If a different line spacing is set for the receipt/journal paper and slip,
and both are selected for printing, then using the Paper Feed button
to print and feed paper causes the line spacing to be set for the slip.
