Filter
Top Products
38
C
HAPTER
3: I
NSTALLING
THE
S
WITCH
4007
Installing the Chassis on a Table or Shelf
This section describes how to attach plastic feet to the
chassis and how to install the chassis on a table or a
shelf.
WARNING:
Safety regulations state that the selected
table or shelf must be able to support at least 115.6
kg (255 lb), which is three times the weight of a fully
loaded chassis.
Attaching the Chassis Feet
To install plastic, molded feet on the Switch 4007
chassis, follow these steps:
1
Using two people, lift the chassis onto the table or
shelf.
2
Position the chassis on its side so that you can access
the bottom of the chassis.
3
Remove the four feet and the four 6-32 Phillips-head
screws from the hardware kit.
4
Using a Phillips screwdriver, screw the feet to the
bottom of the chassis. See Figure 9.
Figure 20
Attaching Plastic Feet to the Switch 4007 Chassis
Installing the Chassis on a Table or Shelf
To install the chassis on a table or on a shelf, follow
these steps:
1
Lift and turn the chassis upright on its installed plastic
feet.
2
Position the chassis on the table or shelf so that the
chassis rests upright squarely on the table or on the
shelf (on all four feet).
3
Ensure that the front, sides, and the rear of the chas-
sis are unobstructed and easy to reach.