Filter
Top Products
2
I
NSTALLING
THE
S
YSTEM
This chapter describes how to install your
CoreBuilder
®
9400 system on a table top or in a
distribution rack.
See Appendix C for site requirements.
■ To install the CoreBuilder 9400 system on a table
top, read these sections:
■
“Before You Begin” (the next section)
■
“Installing the System on a Table Top” on
page 17
■ To install the CoreBuilder 9400 system in a
distribution rack, read these sections:
■
“Before You Begin” (the next section)
■
“Installing the System in a Distribution Rack” on
page 18
Before You Begin
Before you begin this procedure, be sure to:
■ Move the CoreBuilder 9400 system close to where
you plan to install it.
Install the system near an easily accessible power
outlet. You can power down the system only by
removing the power cord from the power source.
■ Have a No. 2 Phillips screwdriver available.
■ Have the system mounting kit available. See
Tab le 3.
Installing the System on a Table Top
To install the CoreBuilder 9400 system on a table top,
follow these instructions:
1
See Appendix C for site requirements.
2
Turn the system on its side.
3
Remove the protective covering from the rubber feet
and place one foot in each marked area at the four
corners of the unit.
4
Turn the system onto its feet.
5
Verify that the air intake vents and fan exhaust vents
at the sides of the system are not blocked.
You are now ready to cable your system. For
instructions, see Chapter 3.
Tab le 3
CoreBuilder 9400 System Mounting Kit
Item Qty To u se in
Rubber feet
(self-adhesive)
4 Installing the system on a
table top
Mounting brackets 2 Installing the system in a
distribution rack
8-32 x 1/2 Phillips
flat-head screws
8 Installing distribution-rack
mounting brackets
10-32 x 1/2 Phillips
pan-head screws
4 Installing the system in a
distribution rack