Filter
Top Products
1-24
C
H
A
P
T
E
R
1:
G
E
T
T
I
N
G
S
T
A
R
T
E
D
Quick Configuration
This section describes how you can configure the unit to bridge or route
over ISDN links to suit most networking requirements using a simple
forms-based user interface. If you want to connect to a remote site using
leased line WAN links see
“Setting Up a WAN Link”
on
page 1-39
.
If you are unsure about the networking configuration you require, see
“Examples of Typical ISDN Networking Applications”
on
page 1-41
for
more information.
IMPORTANT
The Quick Configuration menu option is designed to be used
only when you set up the unit for the first time. If you want to make any
changes to the unit’s configuration at a later stage, use the management
system menus to make these changes. For more information, see the
AccessBuilder ISDN Access Router Software Reference
guide
.
Starting Quick Configuration
1
Using a VT100 compliant terminal emulator, setup the terminal
emulation to VT100 with communications parameters set as follows;
select the COM port to be used for data transmission, 9600 bits/s – 8
data bits – 1 stop bit – no parity, with flow control set to none.
Example Using Windows 3.1 Terminal Application
Start the Windows ‘Terminal’ application. Using a mouse, click on
Settings
in the status bar to reveal the menu.
From the menu:
a
Select the
Terminal Emulation
dialo
g b
ox; confirm that
DEC VT-100
(ANSI)
is selected.
b
Select the
Communications
dialog box; check the communications
parameters are set as above.
c
Select the
Terminal Preferences
dialog box; confirm that all
check-boxes have been cleared.