Actron 9640 Scanner User Manual


 
Global OBDII Diagnostics
4 – 2 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
4
4
Vehicles may support two types of I/M Readiness:
SINCE DTCs CLEARED shows monitor status since DTCs were erased.
THIS DRIVING CYCLE shows monitor status since current drive cycle
started.
If monitors are not supported for THIS DRIVING CYCLE, Scan Tool only shows
monitors for SINCE DTCs CLEARED with no header on line 1.
Select I/M Readiness from OBDII
Function List menu and press
ENTER
.
Scan Tool displays message stating whether or not I/M Readiness monitors are
completed.
Use
DOWN
arrow key to view monitor statuses. If both monitor types are
supported, use
LEFT/RIGHT
arrow keys to toggle between monitor types.
A status of “OK” means required driving conditions for that monitor have
been met and monitor has ran to completion.
A status of “Inc” means required driving conditions for that monitor have
not been met or monitor did not complete its cycle.
A status of “N/A” means vehicle does not support that monitor.
When done, press
BACK
key to return to OBDII Function List.
OBDII Function List ?
1)I/M Readiness
2)Read Codes [
3)Pending Codes ~
Not All Supported
On-Board Readiness
Tests Are Complete.
Use [ To View ~
On-Board Readiness ?
Tests Are Complete
Use [ To View Test~
THIS DRIVING CYCLE
Misfire Monitor n/a
Fuel System Mon ok [
Catalyst Mon inc ~
SINCE DTCS CLEARED
Misfire Monitor ok
Fuel System Mon ok [
Catalyst Mon inc~