Actron 9640 Scanner User Manual


 
Ford Historic Self-Test Routines
6 – 8 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
6
MECS Erase Codes
Select Erase Codes from the Ford
Function List and press
ENTER
.
Press
ENTER
after each message.
Never Lay Tools On Vehicle Battery. Tools May Create
Shorts And Cause Harm To User And Damage To Tools,
Battery And Electrical System.
Follow all instructions on the display.
1) Turn Ign Key Off.
2) Remove Negative (–) Battery Cable.
3) Hold Down Break Pedal for 10 Seconds.
4) Reattach Negative (–) Battery Cable.
All continuous memory codes should be erased. Press
FUNC
to return to the
Ford Function List.
Wiggle Test (EEC-IV Vehicles)
The Wiggle Test, often referred to as the Continuous Monitor Test, is used to
locate intermittent electrical faults on EEC-IV vehicles. When the test is
activated, the tool will beep and display a message when a fault is present. If
the problem is fixed or goes away, the tone and message goes away. Refer to
the applicable vehicle service manual for circuits that can be tested.
If the Alert was turned off in the tool Setup menu, it will be automatically
activated for the Wiggle Test. Once the Wiggle Test is complete, the alert
returns to its previous setting.
Select Wiggle Test from the Ford
Function List and press
ENTER
.
Ford Function List ?
3)Review Codes ]
` 4)Erase Codes [
5)Wiggle test ~
Only Memory Codes
Are Erasable!
Press ENTER to Cont~
To Erase KOEO And
KOER Codes, You Must
Fix Cause of Code.
Press ENTER to Cont~
!
CAUTION
Ford Function List ?
3)Review Codes ]
4)Erase Codes [
` 5)Wiggle Test ~