Actron 9640 Scanner User Manual


 
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 5 – 15
GM Enhanced (OBD II) Diagnostics
5
View Freeze Data
When an emission-related fault occurs, certain vehicle conditions are recorded
by the on-board computer. This information is referred to as a Freeze Frame
data. The information is a “snapshot” of the operating conditions at the time of
a fault. This data can be overwritten by faults with a higher priority.
Only one Freeze Frame can be kept per module. Switching from Engine
to Transmission will overwrite Data. Make sure to print data before
selecting a diffrent module.
If codes were erased, then freeze frame data may not be stored in vehicle
memory.
Select View Freeze Data and press
ENTER
. A vehicle can store more than
one Freeze Frames or Failure records.
Use the
UP/DOWN
arrow keys to select
a DTC.
DTC Definition(s)
Pressing the
RIGHT
arrow key displays
the DTC definition. Use the
UP/DOWN
arrow keys to view each DTC definition.
Pressing the
BACK
or
LEFT
arrow key
exits to the Freeze Data for: screen.
The cursor is positioned in front of the last DTC definition viewed before exiting.
Fault Data
Select the Freeze Frame/Failure
Record and press the
ENTER
key to
display the PIDs recorded at the time of
the fault.
Use the
UP/DOWN
arrow keys to move
through the list. The LEFT/RIGHT arrow keys page Up/Down through the list.
When done, press the
FUNC
key to return to the GM Function List.
O2 Monitor Test
Refer to “O2 Monitor Test” on page 4-8 of Global OBDII Diagnostics.
Diagnostic Monitor Test
Refer to Diagnostic Monitor Test of the Global OBDII Diagnostics.
Freeze Data for:
` P0107(Frz Frame)
P0405(Failure Rec) [
P1604(Failure Rec) ~
P0107 Mod$10 1 of 4
MAP/BARO
Circuit Low Input [
~
FAIL REC DTC PO405
LOOP STATUS N/A
CALC LOAD(%) 0.0[
ECT(
o
F) -40.0~