Filter
Top Products
MM701G and MM702G User Manual 7
2
ACCESSING THE WEB INTERFACE
FOR MODEM MANAGEMENT
Use the Web interface as the most comprehensive and convenient way to set up and manage the
modem. This chapter provides steps to help you access the Web interface pages for
configuration and management of the modem.
Access to the command-line interface is available through the modem console port or over
a network using a telnet session. Not all configuration and management features, however,
are supported through the command-line interface. See Appendix A, “Accessing the
Command-Line Interface” on page 99 for instruction on using the command-line interface for
configuration and management.
STEP 1—ASSIGN IP ADDRESSES
To access the modem Web interface, the management PC must be on the same LAN IP subnet
as the modem. Default values are shown to the right. Do one of the following:
• Change the management PC IP address so that it is on the
same subnet as the modem (go to page 8 and begin with
Step 1).
• Change the IP address of the modem 10Base-T (LAN) port
to a value assigned by your network administrator using the
command-line interface (go to “Set Up the LAN” on
page 104).
Modem Defaults
Subnet 10.0.0.0
Subnet Mask 255.255.255.0
IP Address 10.0.0.1