Filter
Top Products
Configure a New WAN Session
26 MM701G and MM702G User Manual
CONFIGURE A NEW WAN SESSION
You can configure up to 32 total PPPoA, PPPoE, 1483-Bridge, and
1483-Router sessions for the modem. See page 25 for the maximum
number of sessions per each protocol type that can be set up.
A default bridging session is set up. From the WAN configuration
page, define the parameters for each session.
1 Select
WAN on the menu bar to access the WAN Configuration page.
2 To add a new session, choose one of the following protocols from
Select a new session type.
•
RFC 1483 bridged if the modem forwards packets based on MAC addresses. You can
enable Spanning Tree when you select Bridge sessions. See “Change Spanning Tree
Setting” on page 51.
•
RFC 1483 routed if the modem routes packets based on IP addresses.
•
PPPoA routed if the modem establishes PPP sessions over ATM with the service
provider and routes packets based on IP addresses.
•
PPPoE routed if modem establishes PPP sessions over Ethernet with the service
provider and routes packets based on IP addresses.
3 Click
Configure to access the session page for the protocol type you selected.
4 Go to the appropriate section that follows for the protocol that you selected.
WAN
WAN Setup