Filter
Top Products
Chapter 2. Installation
24 Express XRT User Guide 61202.153L3-1
14.In the Make a New Connection menu, enter the number to di-
al.
15.Click NEXT.
16.Click Finish to complete the new connection setup.
17.To use this connection, select it from My Computer, Dial-Up
Networking. Windows dials the number using the modem
and properties as configured. When using the connection the
first time, network log in information such as the user name
and password must be entered. This information should be
provided from the Internet Service Provider.
VT 100 TERMINAL EMULATION
The Express XRT can be configured using any communications
package supporting VT 100 terminal emulation. To enter into the
menus, type AT!V Enter. To go to a particular menu, press the hot
key sequence for that menu. The main branches of the menu tree
and their hot keys are as follows:
STATUS (Ctrl + V)
TEST (Ctrl + T)
CONFIG (Ctrl + C)
DIAL (Ctrl + D)
Ensure that the communications package is configured to pass these
Control Sequences through to the Express XRT.
To exit the menus, press Ctrl + X. The Ctrl + X command also
places the unit back on-line if a call is connected.
Some features in the Express XRT do not immediately take effect
upon selection. This prevents unintentional reconfiguration of
the Express XRT during an active call. Items such as Protocol and
Call Type take effect only at the beginning of a new call.
VT 100 Configuration
1. After connecting a VT 100 terminal enter the command AT!V
followed by Enter. The Configuration screen is the first screen
displayed. An illustration of this screen is shown in Figure 2-
15 on page 25.
2. Enter the area code.
3. Enter ISDN phone number 1.