Filter
Top Products
Appendix C. Status Buffer Messages
76 Express XRT User Guide 61202.153L3-1
CID>0 rcvd
Received an incoming call from a third party during negotiations
with a far-end BONDING unit on the use of the second Bearer
channel.
Connect Timeout
Call attempt does not connect in x amount of time.
Deactivated
No signal (INFO0) between Express XRT and NT1.
DEST NOT ISDN
The number called is not ISDN (warning only).
DEST_OUT_OF_ORDER
The called number is out of order.
Dial
The Express XRT placed a call on either the first or second chan-
nel. The number called is displayed following the message.
Disconnect
The call on either the first or second channel was disconnected
from the network. The far-end phone number is displayed if
available. Ensure flow control setting match on both terminal
adapters.
Disconnected
Layer 1 is up (INFO4 received) but no layer 2 or 3 activity. This is
the normal state of a EuroISDN switch if no call is active and the
switch has not dropped layer 1 (physical layer).
Disconnect Req
Far-end unit disconnected during BONDING negotiation.
DTR not up
Express XRT tried to place a call in a dialing mode that requires
DTR to be in an active state, but it is not.
Dump call
The Express XRT could not accept an incoming call because it was
already involved in a call.
Dump
An incoming call on either the first or second channel was dis-
carded by the Express XRT. The calling number is displayed if
available.