Filter
Top Products
:ANAPURNA XL² OPERATOR MANUAL
AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]
27
]
8/08/2008
]
- Switch OFF the main power, by using the main-switch
(big round turn switch at the rear of the engine).
- Turn off the compressed air.
-
--
-
THE ENGINE IS NOW READY FOR A LONG STAND STILL
THE ENGINE IS NOW READY FOR A LONG STAND STILLTHE ENGINE IS NOW READY FOR A LONG STAND STILL
THE ENGINE IS NOW READY FOR A LONG STAND STILL
-
--
-
STARTUP -- preparing the engine to print again:
- Remove the capping plate. Verify that the headbase plate is turned higher than
anything that is laying down onto the conveyor belt.
- Turn the compressed air back on. (still at “0” on display)
- Turn ON the main power switch at the rear side of the engine.
- Turn and pull the emergency stop back outwards.
- Startup the engine and switch the engine’s PC back on.
(ATTN.: carriage will move slowly to the Home position)
- Move the carriage back to the Purge position.
- Switch all ink valves back to “I”
- Perform a long purge, until you see ink appearing out of the heads.
- Let the ink drip for 1 minute
- Set the vacuum pressure back to “-.036”. (Negative Pressure)
- Clean the heads and base plate.
- Perform a nozzle check and purge again if necessary.
-
--
-
THE ENGINE IS NOW READY
THE ENGINE IS NOW READY THE ENGINE IS NOW READY
THE ENGINE IS NOW READY TO PRINT AGAIN
TO PRINT AGAIN TO PRINT AGAIN
TO PRINT AGAIN -
--
-