Filter
Top Products
:ANAPURNA XL² OPERATOR MANUAL
AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]
34
]
8/08/2008
]
10
1010
10.
. .
. Head Base
Head Base Head Base
Head Base –
––
– Height Control
Height Control Height Control
Height Control.
..
.
10.1. Automatic “Head Base Height” Setup
This is done in the “Head Gap Control”, which can be found in the Setup Parameter
window.
Check or change the following Parameters to set the Head Base Height:
Gap:
Enter the value that you want the “Head Base” to be above the media surface.
(Recommended value: 1.5mm; For heat sensitive media, you can go higher to
avoid that too much heat is accepted by the media, and as a result the media
is extended and can touch the head or is printed with bad quality.
Change of this value requires however other values as ‘offset’ and ‘bi-
alignment offset parameters.
Don’t forget to save the Setup parameter list to keep the change.