Filter
Top Products
[ROUTe:]
The ROUTe command subsystem controls switching and scanning
operations for Form C Switch modules in a switchbox.
Subsystem Syntax [ROUTe:]
CLOSe <channel_list>
CLOSe? <channel_list>
OPEN <channel_list>
OPEN? <channel_list>
SCAN <channel_list>
:MODE NONE | VOLT
:MODE?
CLOSe [ROUTe:]CLOSe <channel_list> closes the Form C Switch channels
specified by channel_list. channel_list has the form (@ccnn) where cc =
card number (01-99) and nn = channel number (00-15).
Parameters
Parameter Name Parameter Type Range of Values
<channel_list> numeric cc00 - cc15
Comments • Closing Channels: To close a single channel, use [ROUTe:]CLOSe
(@ccnn); for multiple channels use [ROUTe:]CLOSe
(@ccnn,ccnn,); for sequential channels, use [ROUTe:]CLOSe
(@ccnn:ccnn); for groups of sequential channels, use
[ROUTe:]CLOSe (@ccnn:ccnn,ccnn:ccnn); or any combination.
Closure order for multiple channels with a single command is not
guaranteed.
• Related Commands: [ROUTe:]OPEN, [ROUTe:]CLOSe?
• *RST Condition: All channels open.
Example Closing Form C Switch Channels:
This example closes channels 100 and 213 of a two-module switchbox (card
numbers 01 and 02).
CLOS (@100,213) Close channels 100 and 213. 100
closes channel 00 of card #1 and
213 closes channel 13 of card #2.
52 Agilent E1364A Form C Switch Command Reference Chapter 5