Filter
Top Products
Chapter 3 Front-Panel Operation
Storing and Recalling Operating States
41
3
4
Save the operating state.
The operating state is now stored. To recall the stored state, go to the following
steps.
This message appears on the display for approximately 1 second.
5
Turn on the recall mode.
Memory location “1” will be displayed in the recall mode.
This message appears on the display for approximately 3 seconds.
6
Recall the stored operating state.
Turn the knob to the right to change the displayed storage location to 3.
If this setting is not followed within 3 seconds with key stroke, the
power supply returns to normal operating mode and will not recall the
instrument state 3 from memory.
7
Restore the operating state.
The power supply should now be configured in the same state as when you
stored the state on the previous steps.
This message appears on the display for approximately 1 second.
• Remote interface operation:
*SAV {1|2|3} Store an operating state to a specified location
*RCL {1|2|3} Recall a previously stored state from a specified location
DONE
RECALL 1
RECALL 3
DONE
Store
Recall
Recall
Recall