Filter
Top Products
OmniSwitch 6600 Family Chassis and Hardware Components Removing Uplink and Stacking Modules
OmniSwitch 6600 Family Hardware Users Guide September 2006 page 2-42
Removing Uplink and Stacking Modules
To remove an uplink or stacking module from the chassis, follow the steps below:
Anti-Static Warning. Before handling any component, free yourself of static by wearing a grounding
strap, or by grounding yourself properly. Static discharge can damage the switch and the uplink or stack-
ing module.
1 Loosen the two captive screws, located at the left and right sides of the module’s front panel. If neces-
sary, use a Phillips screwdriver to loosen the screws.
Note. Be sure that both captive screws are completely disengaged from the threaded holes in the chassis
before continuing.
Loosening the Captive Screws
EXPANSION/STACKING
51
52
LIN
K
/A
CT
LINK
/A
C
T