Filter
Top Products
037
037
/
CHAPTER 5: INSTALLING ADDITIONAL OR REPLACEMENT COMPONENTS
To avoid damaging the desktop, perform the following steps before you begin
working inside the desktop.
Ensure that the work surface is at and clean to prevent the desktop cover 1.
from being scratched.
Turn o your desktop (for more information, see “Turning O Your Desktop” 2.
on page 36).
CAUTION: To disconnect a network cable, rst unplug the cable from
your desktop and then unplug the cable from the network device.
Disconnect all telephone or network cables from the desktop. 3.
Disconnect your desktop and all attached devices from their electrical 4.
outlets.
Press the power button to ground the system board.5.
Before Working Inside Your Desktop
Use the following safety guidelines to help protect your desktop from potential
damage and to help to ensure your own personal safety.
WARNING: Before working inside your desktop, read the safety
information in the “SAFETY, ENVIRONMENTAL, AND REGULATORY
INFORMATION“ that shipped with your computer. For additional safety
best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION: Handle components and cards with care. Do not touch the
components or contacts on a card. Hold a card by its edges. Hold a
component such as a processor by its edges, not by its pins.
CAUTION: Only a certied service technician should perform repairs on
your desktop. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a
wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION: When you disconnect a cable, pull on its connector or on
its pull-tab, not on the cable itself. Some cables have connectors with
locking tabs; if you are disconnecting this type of cable, press in on the
locking tabs before you disconnect the cable. As you pull connectors
apart, keep them evenly aligned to avoid bending any connector pins.
Also, before you connect a cable, ensure that both connectors
are correctly oriented and aligned.