Filter
Top Products
AT-29xx Series Gigabit Ethernet Network Adapters Installation Guide
25
Installing a Network Adapter Card
The following instructions apply to installing an AT-29xx Series Gigabit
Ethernet Network adapter in most systems. Refer to the manuals that were
supplied with your system for details about performing these tasks on your
particular system.
To install the network adapter card, perform the following procedure:
1. Review the “Pre-Installation Checklist” on page 24 and “Reviewing
Safety Precautions” on page 22.
Before installing the adapter, ensure the system power is OFF and
unplugged from the power outlet, and that proper electrical grounding
procedures have been followed.
Warning
High voltage inside the system presents a safety hazard. Make sure
the power is off before removing the cover.
2. Remove the system cover and select any appropriate empty PCI slot.
See Figure 1.
If you do not know how to identify an appropriate PCI slot, refer to your
system documentation.
Figure 1. Removing the PC Cover