Filter
Top Products
Chapter 5: Setting Advanced Properties
54
Opening Advanced Properties
In most cases, the default property values available on the Advanced Tab
are appropriate although you can change any of the available options to
meet the requirements of your system. You must have Administrator
privileges to modify the driver software. After the driver software has been
installed, you can use the following procedures to verify or change the
adapter properties:
“802.1p QOS” on page 55
“Ethernet@Wirespeed™ (AT-2972/T2 only)” on page 57
“Flow Control” on page 57
“Jumbo Mtu” on page 58
“Interrupt Moderation” on page 59
“IPSec Offload” on page 60
“Large Send Offload Property” on page 61
“Network Address” on page 62
“Priority & VLAN” on page 63
“Receive Side Scaling” on page 64
“Speed & Duplex Mode” on page 65
“Checksum Offload” on page 66
“VLAN ID” on page 67
“Wake Up Capabilities” on page 68
“WOL Speed” on page 69
Note
After you upgrade the driver software, the Advanced Properties may
change.
Note
The procedures in the sections listed above may differ slightly if the
“Classic Start Menu” is set on your computer.