Filter
Top Products
AT-29xx Series Gigabit Ethernet Network Adapters Installation Guide
65
2. Click the Advanced tab.
The Advanced tab is shown in Figure 21 on page 56.
3. From the Property list on the Advanced tab, select “Receive Side
Scaling.”
4. In the Value list on the Advanced tab, select one of the following:
Enabled
Disabled
5. Click OK.
6. If prompted to restart your computer, click Yes.
Although it is not necessary to reboot the system for new adapter
properties to take effect, rebooting is recommended to reinitialize all
registers.
7. Verify that the port LED operates as described in “LEDs” on page 18.
Speed & Duplex
Mode
The speed and duplex mode property allows you to set the speed of the
adapter as well as the change the duplex mode from full to half. By default,
the duplex mode is set to a speed of 100 Mb in full duplex mode.
To change the speed and duplex mode of an adapter, do the following:
1. For Windows Server 2003 and Windows XP systems, access the
System Properties Dialog Box. See “Modifying Configuration
Properties” on page 39.
For Windows 2008 R2, Windows 7, and Windows Vista systems,
access the Device Manger for your operating system:
To access the Device Manager window in Windows 2008 R2 or
Windows 7, see “Selecting the Device Manager in Windows 2008
R2 and Windows 7” on page 44.
To access the Windows Vista Device Manager, see “Selecting the
Device Manager in Windows Vista” on page 46.
2. Click the Advanced tab.
The Advanced tab is shown in Figure 21 on page 56.
3. From the Property list on the Advanced tab, select “Speed & Duplex.”
4. In the Value list on the Advanced tab, select one of the following:
10 Mb Full
10 Mb Half