Filter
Top Products
System Commands
4-4
init-nvram
This command resets the non-volatile RAM (NVRAM) on the SNMP
Agent to default values. Change will take effect after boot (warm or
cold reset).
get-sw-file
This command retrieves the SNMP Agent Software file name.
set-sw-file
set-sw-file <filename>
Sets the name of the file downloaded by TFTP. This name must match
the name of the agent software file on the TFTP server.
get-tftp-srvr
This command retrieves the IP address of the TFTP server which the
Agent will use to download software (see sw-dnld).
set-tftp-srvr
set-tftp-srvr < IP address>
Sets the IP address of the TFTP server used for downloading.
set-tftp-mode
This command sets the TFTP download mode.
SYS_console> set-tftp-mode {client|server}
Switch Tftp client/server is enabled for next
download.
Refer to Appendix A, Software Downloading for more details.
get-tftp-mode
This command retrieves the TFTP download mode and requires no
argument.