Filter
Top Products
15-1
Chapter 15
Using an SNMP Manager
This chapter contains instructions for the configuration and
management of the AT-8116 SNMP Management System.
Configuring the AT-8116 SNMP Agent
Once connected to the network and powered ON, the AT-8116 starts
operating according to factory-set default values. However, to ensure
proper operation and maximum performance specific to your
network configuration and to provide SNMP access, some
environment-specific parameters must be configured through the
Command Line Interface.
If you are configuring the switch for the first time:
Global Setup 1. Connect a terminal to the RS-232 connector.
2. Log in to the Command Line Interface.
3. Initialize all the AT-8116 parameters to their default values (see
Table 1, System Default Values). Use the following command
sequence:
init-nvram (deletes all current NVRAM configrations)
warm-reset (loads the NVRAM configuration)
4. Wait until you see the LOGIN prompt again. Login to the CLI. Now
all system parameters have been initialized to their default values.