Filter
Top Products
Using an SNMP Manager
15-2
IP Setup 1. Modify the system IP configuration to match your IP network. Use
the set-ip-cfg command in order to provide an IP address, a
netmask and a broadcast address (see IP Commands). For
example:
set-ip-cfg 129.001.001.064 255 255.255.255.0
129.001.001.000
Check that the actual IP configuration matches the desired one:
SYS_console>get-ip-cfg
The device IP address, netmask and broadcast are:
IP address: 129.001.001.064
IP netmask:255.255.255.000
IP broadcast: 129.001.001.000
2. Set the default gateway address using the set-gatew command.
This should be a station that can route IP packets to non-local IP
networks. For example:
SYS_console>set-gatew 129.1.1.1
3. Confirm that the default gateway IP address was properly
accepted:
SYS_console>get-gatew
Device default gateway address is :
129.001.001.001