Filter
Top Products
AT-8116 User’s Guide
1-5
Testing the Installation
After you have completed the installation, use the CLI ping
command to test for connectivity. See Chapter 15, “
Using an SNMP
Manager
”.
The ping command sends an echo request to the host specified in
the command line. For example, to test connectivity from the switch
to a workstation with an IP address of 192.1.1.126, use the following
command:
SYS_console>ping 192.1.1.126 2
Use CTRL-C or ping-stop to stop the ping
process
SYS_console>192.1.1.126 Alive. echo reply: id
4643, seq 1, echo-data-len 0
191.1.1.126 Alive. echo reply: id 4643, seq 2,
echo-data-len 0
PING process stopped - statistics:
ICMP echo requests: 2
ICMP echo responses: 2
PING process - press <CR> for prompt
SYS_console>
Accessing the Command Line Interface Remotely
All commands work exactly as if the serial interface were being used.
Five telnet sessions may be active at any given time. This means that
after the fifth telnet session is established, all other telnet
connections will be refused until one of the current sessions is
closed.