Filter
Top Products
IP Commands
5-2
Sets the IP address of the SNMP Agent. If no IP address was
previously set (as is the default factory configuration), the new value
will be used immediately and saved into NVRAM. Otherwise the new
value will only be stored in the NVRAM, and the user must execute a
“warm-reset” to effect the change.
get-ip-cfg
This shows the complete current IP configuration - address, network
mask and broadcast address.
-- If an address has been previously defined:
SYS_console> get-ip-cfg
The device IP address, netmask and broadcast are:
IP address : 149.035.200.032
IP netmask : 255.255.255.000
IP broadcast : 149.035.200.255
-- If no address is defined:
SYS_console> get-ip-cfg
The device has no IP Address defined.
SYS_console>
set-ip-cfg
set-ip-cfg <IPaddress> <netmask> <broadcast>
Sets IP address, network IP address and broadcast IP address. If no IP
configuration was previously set (as is the default factory
configuration), the new values will be used immediately and saved
into NVRAM. If a previous IP configuration was being used, the new
configuration will be saved in NVRAM for the next session. In order to
use the newly defined values immediately, reset the system using the
“warm-reset” command.
Note
If the IP configuration is not specified, the agent will not respond to
any in-band requests, including ping messages.
-- If no IP Config. is defined: