Filter
Top Products
Take Apart Trackpad Assembly - 16
1 Using a T-8 torx driver,
remove the four
mounting screws and lift
off the trackpad carrier.
Replacement Note:
Make
sure you install the lower
left screw in the proper
hole.
Replacement Note:
Thread the trackpad cable
through the center of the
carrier. Align the upper
middle hole of the carrier
with the plastic tab on the
top case. Set the carrier into
place.
Mountin
Screws
(long)
Trackpad Carrier
Trackpad Cable
Mounting
(short)
Screws
Plastic Tab
Trackpad