Filter
Top Products
3In the SCSI Disk Mode section of the control panel, click the ID number you want
to assign.
If you are connecting the PowerBook to an existing SCSI chain, make sure to
give it an ID number different from those of the other devices. (Many devices
include an ID number indicator on the back panel.)
4Close the PowerBook Setup control panel.
5 Turn off the PowerBook by choosing Shut Down from the Special menu.
6Shut down the computer you are connecting to, and turn off any other devices in the
SCSI chain.
7Connect the small connector on the Apple HDI-30 SCSI Disk Adapter to the SCSI port on
your PowerBook.
8If you are connecting the PowerBook directly to the other computer (rather than to an
external device in the SCSI chain), attach a SCSI system cable to the other computer.
9Connect the large connector on the Apple HDI-30 SCSI Disk Adapter cable to a SCSI
cable attached to the SCSI port on the last device in the SCSI chain, or to the SCSI
system cable on the other computer.
Remove the terminator from the last device before connecting the
PowerBook. (If the last device has an internal terminator, disconnect the
device and connect the PowerBook to the end of the SCSI chain. An Apple-
authorized service provider can remove the terminator.)
10 Turn on the PowerBook by pressing the Power On key.
WARNING
Always shut down the PowerBook before connecting or
disconnecting the SCSI disk adapter cable. Connecting the adapter cable
while the computer is turned on can damage the computer.
32
Chapter 3