Filter
Top Products
25
PBX GATEWAY#configure
Enter configuration commands, one per line. End with CTRL/Z
PBX GATEWAY (config)#
Step 3: Assign the IP address and the subnet mask
Command: PBX GATEWAY (config)#ip address <ip-address> <subnet-mask>
PBX GATEWAY (config)#ip address 203.79.238.144 255.255.255.128
System must then be restarted
PBX GATEWAY (config)#
Step 4: Assign the default gateway
Command: PBX GATEWAY (config)#ip default-gateway <address>
PBX GATEWAY (config)#ip default-gateway 203.79.238.186
PBX GATEWAY (config)#
Step 5: Save the configuration to non-volatile memory immediately. If you power the device off
immediately, your new configurations will be lost when you switch the power off. However, the system
will automatically save the configuration if no input has been detected within one minute.
PBX GATEWAY (config)#dbflush
PBX GATEWAY (config)#
Step 6: Switch back to privileged mode
PBX GATEWAY (config)#exit
PBX GATEWAY#
Step 7: You must now restart the system in order for your changes to take effect. After the restart
command is issued, the system will prompt for a confirmation.
PBX GATEWAY#restart
This command resets the system. System will restart operation code agent.
Reset system, [Y]es or [N]o? Yes