Filter
Top Products
31
Password: ******
PBX GATEWAY#
Step 2: Enter Routing Mode
PBX GATEWAY#routing
PBX GATEWAY (routing)#
Step 3: Create an entry for this slave gateway
Command: PBX GATEWAY (routing)#slave add <ffffff-ffffff, the MAC address of
this Slave Device>
PBX GATEWAY (routing)#slave add 000362-000004
PBX GATEWAY (routing)#show slave
0001. 00-03-62-00-00-01
0002. 00-03-62-01-00-01
0003. 00-03-62-01-00-1B
0004. 00-03-62-01-00-30
0005. 00-03-62-00-00-04
0006. 00-03-62-01-00-06
Using the Phone Set Interface to create an entry for the Slave Gateway on the Master Gateway
(please refer to the Phone Set Interface Configuration Procedures for more detailed information)
Step 1: Takethe handset off the phone.
Step 2: After hearing the dial tone Dial the PROG Access Code.
Step 3: Enter the Password.
Step 4: Enter code "22" to begin creating an entry for the slave gateway.
Step 5: Enter the last 6 characters of the MAC address of the slave gateway (00-03-62-00-00-04) as
"000004" and "#" as the ending prompt. You will then hear the confirmation tone.
Place the handset on the phone phone to end your configuration session.
Configure the Group ID and the MasterIP Address on the Slave