28
3.7 Configuring the Master Device
Using the System Console Interface or Telnet
Step 1: Enter Privileged Mode
PBX GATEWAY>enable
Password: ******
PBX GATEWAY#
Step 2: Enter Routing Mode
PBX GATEWAY#routing
PBX GATEWAY (routing)#
Step 3: Configure this device as the master gateway by setting its value to 0.0.0.0
3
Command: PBX GATEWAY (routing)#master_ip 0.0.0.0
PBX GATEWAY (routing)#
(System must be restarted before the new configurations will take effect )
Step 4: Configure the group ID that is used for the entire group
Command: PBX GATEWAY(routing)#group_id <the group ID for the entire group, same
value for master and slaves that are in the same group>
PBX GATEWAY(routing)#group_id 2000
System must now be restarted
PBX GATEWAY(routing)#
Step 5: Go back to Privileged Mode
PBX GATEWAY (routing)#exit
PBX GATEWAY#
Step 6: Restart the system in order for the settings to take effect. After the restart command is issued,
the system will prompt for a confirmation.
PBX GATEWAY#restart
This command restarts the system. The system will now restart operation code
3
The default master IP address is 0.0.0.0 and the default role of each device is to act as the master device. To change a slave device back into
a master, just change the IP address to "0.0.0.0".