Filter
Top Products
80
group_id
Sets the group ID
master_ip
Sets the master's IP address
internal_ac
Sets the internal access code for inter-gateway calls
intn_code
Sets the international access code for in-bound analysis
local_pstn_ac
Sets the local PSTN trunk access code (if it exists)
long_distance
Sets the long distance access code for in-bound analysis
office_excp
Sets the long distance access code for in-bound analysis
oper_code
Sets the code to reach the operator of the PBX system
pend-restart
Perform warm start while system is idle
pin
Sets or deletes a pin code
ping
Checks the IP configuration or network connections
prefix
Sets the device’s prefix number
probe-hook
Enable cadence probe state
probe-remove
Disable cadence probe state
prog_ac
Sets the device’s phone set program mode access code
region_id
Sets the region/ID information for the proper ringing pattern,
cadence and other regional related profiles
rtp_base
Sets the RTP base port number
retransmit
Sets the call retransmit count
service_port
Sets the Service port for Telnet or Web
show ac_summary
Shows a summary of the access code configurations
show call_route
Shows the device’s routing table
show channel
Shows the channel summary
show date
Shows the date
show ethernet
Shows Ethernet information
show flash
Shows the flash time settings
show history
Shows the previous commands that were issued
show ip
Shows the IP settings
show line
Shows the console settings
show location
Shows the location information
show pin
Show all pin codes for transit calls
show routing-config
Shows the device’s current operating routing mode
configuration
show running-config
Shows the current running configuration
show service_port
Shows the service port for Telnet or Web
show slave
Shows the slave device (if the device is set to master)
show tftp
Shows the TFTP server’s IP address
show time
Shows the current time
show version
Shows the firmware version
slave
Sets or deletes a slave device
t38_fax
To add/del channels to support the T.38 Fax function
tcwarn_time
Sets the transit call warning time
transit_ac
Sets the transit access code
transit_call
Enables or disables the device’s transit call
udp_port
Sets the UDP port number
vad
Enable or disable the voice activity detection