82
5.2 Greeting Message Recording Procedure
To record the greeting message into the PBX gateway, the user must switch to the recording mode after
entering the Phone Set Configuration mode and pressing the item code “99”. If the user has already
recorded a greeting message, he or she can use the item code “96” to hear it.
In the recording mode, to prevent accidental use the recorded voice will not be stored automatically. You
must press "*" to start recording then "#" to stop recording. You can check your recorded message by
pressing "0", if the recording is satisfactory, press "9#" to store it onto none vanished memory (NVRAM), it
will take few seconds to
save the greeting message and give you confirmation tone if the action is done.
The recorded message can be uploaded to or downloaded from the PBX gateway by using an FTP client
application.
Press *
to start
recording
PROG
Access Code
Hook Off
Password
99 -item code
to recording
mode
Dial Tone
Confirmation Tone
Press #
Store
Recording
Message
Temporarily
Play
temporary
recording
Save the
recording to
FlashROM
Press #
Press 0
Press 9#
Confirmation
tone
Press #