ArtDio IPE 1000 Network Card User Manual


 
43
Category Entry Description Data
Type
Range
Transit
Call
Function
Enable or disable Transit Calls RW Enable/Disable
Transit
Call
Waiting
Time
The timer for sending a warning
tone to the caller while a transit
call is taking place.
RW (1~60) min
(Default=3)
CDR
Report
Enables or disables CDR report
output
6
RW Enable/Disable
Greeting
Mode
There is no message recorded by
default.
You can record your own greeting
message and select how many
times to play the recording.
7
RW Default(Not to
play), Play
Recording
Once, twice, 3,
4, 5, 6, 7, 8
times
Auto
Attendant
Shows whether or not your PBX
is equipped with the Auto
Attendant function
RW Provided/Not
Provided
Slave
UDP Port
No.
The UDP port number which
carries Call Control signaling
from this slave devices with other
gateways
RW 0~65535
(default value
is 2000)
Master
UDP Port
No.
The UDP port number which
carries Port Information signals to
the master device
RW 0~65535
(default value
is 2000)
Configuration
RTP Base
Port No.
The Base RTP port number which
carries voice streaming data
between gateways
RW 0~65535
(must be even)
Note 2 The master UDP port number on slave devices should be the same as the definition on the master
device. But the slave UDP port number for each slave may be different for each device.
The configurations of the UDP port number and the RTP port number are related to the firewall settings of
your network (refer to chapter 6 Firewall Configuration). Please consult your network administrator before
making any changes.
6
CDR report works only on models that are equipped with the extra RS-232 CDR output interface
7
You can use the Phone Set Interface to configure the Skip Greeting Access Code (item code 30) to specify the access code while trying to
bypass the greeting message recorded in the device.