Filter
Top Products
79
Category Entry Console Mode Console Command
IP
Address
Configuration
tftp server <ip-address |
domain name>
Download
Path/File
Name
Configuration
tftp filename <filename>
TFTP Server
Start
Downloadi
ng
Privileged Two commands (If the TFTP server IP
address and filename have already
been assigned):
copy tftp :///
Or specify the address and file name
at the same time:
copy tftp ://<ip-address>/
<filename>
If the TFTP server IP address and
filename have been assigned:
If the TFTP servers IP has not been
assigned You may specify the
address and file name
simultaneously:
4.7 Additional Console Commands
Comands Purpose
area
Sets the device’s area code
auto_attn
Sets the auto attendant status
call_route
Sets or deletes an entry in the routing table
cdr
Enables or disables the CDR log
code
Enters the access code configuration mode
country
Sets the device’s country code
cut_through
Sets the access code to skip the greeting message on this
device.
dbflush
Immediately saves the current configuration onto non-volatile
memory. It is recommended that you issue this command
after entering configuration changes. The system will
automatically execute this command if it has detected no
input within a certain time frame.
delete nvram
Resets the configuration to the default value. Also known as
a Factory Reset.
delete nvram
dial_code
Sets the access number for out-bound analysis
exit
Exits the current mode and returns to a higher level
end
Returns to Privileged mode
extension_len
Sets the number of digits for the PBX extension
fax
Sets the T.38 Fax relay configuration
gid_tmr
Timer to erase the group id when system shuts down
greet_mode
Sets the device’s greeting mode