Filter
Top Products
Management
Page 3-20
Resetting a Group or Device
If you changed the IP address, subnet mask, and/or default gateway for a
management module within a device, that management module needs
to be reset.
Resets can be performed at the device level (resets the entire stack) or
at the group level (resets an individual hub or a management module).
To perform a reset:
1 To reset a group, click once on that group. To reset the
device, do NOT select anything.
2 Click Reset.
Depending on what was selected (either a group or the
device), the Reset Group or Reset Agent table appears,
similar to Figure 3-18 and Figure 3-19.
Figure 3-18 Group Reset table
Figure 3-19 Device Reset table
3 Open the Action drop-down menu and select reset.
4 Click Apply.
The group or device is reset.
▲ Important: To abort the reset, click on the
browser’s back arrow to go back one page.
100NMM PM book Page 20 Wednesday, August 27, 1997 12:40 PM