Asante Technologies 100TX Switch User Manual


 
Management
Page 3-22
Managing Trap Receivers
The Trap Receivers menu allows you to set which management stations
on your network can receive traps. This section describes how to add
and delete a trap receiver.
To add a trap receiver entry:
1 Do not select any item on the Device Page’s front panel
image. (This selects the entire hub stack.)
2 Click Trap Receiver.
The Trap Receiver Table appears, similar to Figure 3-21.
Figure 3-21 Trap Receiver Table
3 Click Add.
The Add Dialog box appears.
4 Open the Status drop-down menu and select valid.
5 Type the IP address of the management station that is
to receive traps in the Trap Receiver Address field.
Important: Do NOT type an IP address of
0.0.0.0.
6 Type the community string for the management station
in the Community String field.
7 Click Apply.
The entry for the management station is added and
appears in the table. If it does not appear, click Refresh.
100NMM PM book Page 22 Wednesday, August 27, 1997 12:40 PM